Thermographs is an ActiveX component for ProTool/Pro and WinCC, with which the segments of radiant heaters can be configured and visualized. Heater segments both with and without pilot heaters (heaters with built-in temperature sensors) can be configured.
For visualization, up to twelve different views of the heater segment are generated, which the user can browse through.
The ActiveX module can be configured with the ProTool/Pro CS (configuration system) or WinCC through the Properties dialog, or directly in the ActiveX module. The ActiveX module can be set into execution mode by simply holding the Shift key and double-clicking the ActiveX module. Each view can therefore already be viewed during the configuration to check that the parameters have been set correctly.
Please contact:
Application Centre
Cologne
Tel.: +49 221 576 3026
Fax: +49 221 576 2936
E-mail: applications@koe.siemens.de
Ordering data
|
Order No.
|
Configuration tool for thermographs
|
GB45B18-NC0634-A0170
|
|